Turn-Key Sign Design, Sign Manufacturing, Sign Installation and Sign Service since 1979.
825 Market Street
Building M, Suite #250
Allen, TX 75013
Now with Live
of Products that Improve Your Signs
Come See Our
$450,000+ SIGN SHOWROOM!
EZ Sign Installations (Do It Yourself)
position on your wall where you want to install the
channel letter sign. Check behind the wall in this
area to insure that the mounting hardware can be
installed, what mounting hardware to use, and that
electrical service can be run to the location.
you secure the sign to the wall depends on the type of
wall. Make sure that your mounting method will
secure the sign permanently, even if it gets hit by a
truck, for instance. If the wall needs
reinforcement you will want to provide it. If your
wall is wood, lags (included) or toggle-bolts (included
also) are usually used, depending on the thickness of
the wood. Sometimes thru-bolts with backer-plates
must be used. If the wall is stucco over dry-wall
toggle-bolts are usually used. If the wall is
concrete or masonry, the wall is usually hammer-drilled
with 5/8” holes and shields for lags (included) inserted
in the wall. If the wall is EIFS (Styrofoam
covered by mesh and stucco) you will probably need to
back the wall with plywood and thru-bolt the sign.
Thru-bolts have not been supplied because walls vary so
greatly in thickness.
raceway’s length and mark its center. Measure from
the center to each mounting hole.
Mark the center
of the location where you want to install the sign on
the wall, and measure from this location and mark the
locations of the mounting holes. Make sure that
they are level, and placed properly vertically in
relation to where you want the sign’s letters to be.
Note that the mounting holes on the raceway are NOT in
the center of the letters vertically.
raceway for the location of the power supply hole, and
mark this location on the wall also. Drill a 5/8”
or larger hole completely thru the wall for passing the
electrical conduit to the rear of the wall.
If practical, a
hanger-bolt (included) can be installed in one of the
end mounting bolt locations. The raceway’s
mounting hole can be slid over the bolt, and temporarily
secured with a nut and washer (also included.) Now
the raceway can be pivoted into place, secured by the
other mounting bolts, then the hanger-bolt can be
Hook up your
electrical and you’re done.
The above are installation
suggestions only. You are solely responsible for the
security of your sign. Our Terms of Sale state
specifically, among other things, that
WARRANTIES HEREIN CONTAINED ARE IN LIEU OF ANY AND ALL
OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING THE
WARRANTY OF MERCHANTABILITY AND OF FITNESS FOR ANY
PARTICULAR PURPOSE. PURCHASER ACKNOWLEDGES THAT IT
IS NOT RELYING ON SIGNS MANUFACTURING'S SKILL OR JUDGEMENT
TO SELECT, FURNISH, INSTALL OR MAINTAIN SIGNS SUITABLE FOR
ANY PARTICULAR PURPOSE AND THAT THERE ARE NO WARRANTIES
WHICH ARE NOT CONTAINED IN THIS SALE.”
Guaranteed Highest Quality . . . Guaranteed Lowest Price™
Tweets and News
15 Product Videos
Allen Signs Manufacturing & Maintenance Corp.
FOR ORDERING OR ASSISTANCE CALL:
Manufacturing™ does not provide any compensation for testimonials.
None of the
photographs in our brochures, or on our website, are “photo-shopped.”
© 1979 - 2018 Sign
Marketing Services ALL RIGHTS RESERVED